We build a building with a frame - a roof

The choice of roof type for building this house was simple. Minimum price and maximum durability. Based on these criteria, slate was chosen. In the future, it is not a pity to change. Yes, and the cost of laying slate is much lower than in the case of metal tiles.

We start with the preparation of rafters. The first mount on a horse. The main thing is to keep the angle.

The second stage is preparing the emphasis on the powerlot (the first-level binding)

Prepare all sets of racks for installation. Stretched legs tightened. It will be the ceiling of the second floor.

We put the first trench farm. Keep upright.

Then we raise all the rafters to the vertical plane.

We place rafters with the necessary step

If necessary, then add more stubby legs.

Knot of the rafters on the upper strap

All support racks put in one plane. This will be the second floor wall.

Check the plane of the roof.

All rafter farm in their places

For the installation of the roof owls, we set up pockets of 50 * 100 mm boards. Take into account the plane of the binder.

View of the rabble with the marmots from the side.

We tighten the rafters to the ceiling beams by knitting with a wire of 4 mm

We mount scaffolding in from a bar 50 * 50 mm

Knot on the floor over the lying. Racks are fixed on both sides.

Racks are fixed with stops

Appeared outlines of the second floor

Boards for filing process with drying oil and dry them.

We start the chimney laying

They started installing a chimney...

We make a canopy above the porch

Stands of a porch we put on columnary foundations

Fastening the rack racks with a rack

For better fitting and bending, we cut the rafter

Siding of the side vents of the roof with a treated board

The board for bindings was pre-pierced with a plan

Frame house

Prepare the slate for laying on the roof

Raising the slate along the guide

View on the back of the sidewalls of the roof. The toe will be covered with a windshield

To preserve the plane, the slates are trimmed;

You can gently slice the slate with the cutters.

We start the slate assembly from the bottom right corner.

Rainbow to successful completion of construction work)))

Slate is concluded.

construction of the roof of the frame house is completed

Read more about building a frame house with your own hands HERE

The next stage - a brick fireplace - here