We cover the house with a windproof film
How to build a house with your own hands - a windproof
In the construction of a frame house the most important is the careful observance of the construction technology. One of the elements that affects the durability of the frame house and its thermal protection, is thermal insulation.
It can be compared to a cloak that we wear on a sweater (insulation), for protection against wind.
Its second function is the ability to remove excess moisture, steam, from building structures.
To properly work the insulation, the windproof film should close the entire house as closely as possible.
Building construction
You can learn about the previous stages in the section '' How to build a house with your own hands ''
In the previous sections, we considered all stages of the construction of a frame house, how to choose a design of a house, to make foundations and to build a frame.
Consider the process of home wind protection:
First of all we fix the wind protection on the beams of the ceiling from below and carefully nail it with a stapler to the lower binding. Then you can floor the floor of the first floor boards.
The next step will be sewing the outer walls. Wire barrier is fastened after laying the outer layer of the insulation.
It is easier to fix the windbreak with vertical stripes, gradually closing the facade.
Construction of a building in our case was divided into two stages:
- Construction of residential 1 st floor with a large attic.
- Warming up the attic and turning it into living rooms.
In the area of slopes, we leave the insulation with a stock. In the future, it will need to be attached to the windows, pre-warming the outer slope.
In areas where vetroisolation is not enough to put patches.
One facade is ready, you can move on to the next.
In the place of adjacency to the roof, we start the windbreak inside, to the surface of the second floor.
Window slopes are framed by a profile for drywall. In the future, the ventilated facade and external slopes will be fixed to it.
So, we walk around all the windows
We insert windows and attach them to the insulation by guiding the profiles
You can fix the vertical profiles and start the outer seam of OSB plates.
Fix the vertical profiles with a step of 600 mm
Leave your comment