Two-storey house project with a garage.

The project of a rational two-storey house with a garage. The width of the building is 12 m. This allows this house to be placed in a narrow area. The dimensions of the house with a garage are 12 x 12.5m. The length of the house, including the terrace and porch, is 18.8 m. The first floor consists of the following premises: a vestibule, an entrance hall with a wardrobe, an office, a kitchen combined with a living room, a bathroom. The entrance to the garage is designed under the stairs to the second floor. There is a boiler room behind the garage. The living room has an exit to a 30 m2 terrace. The second floor has four bedrooms. There are two bathrooms nearby. One of them is a bathroom, the second toilet.

According to geological surveys, there are weak soils under the house. Therefore, the foundation is designed from bored piles. To protect the base of the foundation from getting wet, it is necessary to perform paving around the perimeter of the building. To ensure normal operation and protection of buried structures and foundation soils from soaking, which worsens their physical and mechanical characteristics, it is necessary to perform a vertical layout of the site. In this case, it is necessary to take into account the pathways of natural runoff of surface waters. The standard freezing depth is 1.0 m. There is no groundwater.

In order to avoid the danger of foundation subsidence, before starting construction, it is necessary to carry out geological surveys at the construction site under the location of the house. According to the results obtained, develop a new foundation project.

The floor level of the first floor is taken as a relative elevation of 0.000. Floor of the first floor on a slab of monolithic concrete 150 mm thick with reinforcement. Waterproofing has been installed on the concrete slab. Insulation 200 mm thick is laid on top. On top of the insulation, a 70 mm reinforced cement-sand screed is laid on which the floor covering is laid. The exterior walls of the house are made of 375 mm thick aerated concrete blocks. Internal walls are made of bricks. A monolithic reinforced concrete belt is designed under the ceiling. Partitions of the first and second floors from aerated concrete blocks 100 mm thick.

Ceilings of the first and second floors of the building are reinforced concrete panels. The roof over the house is hipped, above the terrace and porch with one slope. Roofing - metal tile. The use of bituminous tiles is possible. In the case of using heavy clay tiles, rafters and other elements of the roof must be reinforced. For heating and preparing hot water, you can use a solid fuel boiler, gas boiler or electrical appliances. Heating devices are located in a boiler room with an area of ​​14 m2. In the event that a solid fuel boiler or several devices are used for heating, for example a solid fuel boiler and a heat pump, it is necessary to use a heat accumulator with a capacity of 500 - 1000 liters.

If you need a house project with a garage and a gable roof, pay attention to the Gorlitsa project. The area of ​​this house is about 160 m2. You can see the Gorlitsa project here

If necessary, individual projects of engineering sections can be developed: heating and sewerage, ventilation and power supply projects.
en/proektu-domov/dachnyie-doma.html